Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Register Log in
  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

UC3526 Master/Slave Mode

Status
Not open for further replies.
alisarhangpour

alisarhangpour

New Member
I'm going to use 2 uc3526s as a master and a slave. they are synchronized according to the instructions in uc3526 datasheet. It seems that a cap attached to the soft-start pin of the master is just enough and this pin on the slave can be left open, is it correct?
Thank you.
 
Status
Not open for further replies.

Similar threads

F
  • Question
Common Mode Input Range of Opamp ignored?
Replies
6
Views
1K
danadak
danadak
F
SMPS (Switch Mode Power Supply) AC Leakage Experiment
Replies
6
Views
2K
ronsimpson
ronsimpson
R
  • Question
STM32F407xx MCU Configured as Master Tx
Replies
0
Views
3K
retheridge
R
F
  • Question
Why is output capacitance limited for voltage mode flyback?
Replies
0
Views
550
Flyback
F
Tony Stewart
  • Question
Bizarre DIN RAIL SSR Failures in PWM mode to motor.
Replies
5
Views
3K
Tony Stewart
Tony Stewart

Latest threads

New Articles From Microcontroller Tips

Back
Top