B butters Member Jun 3, 2009 #1 hi all... i need to transmit bits from pc to pic... i dont know how to start apart from this code i got hold of Code: #include <p18C452.h> #include <usart.h> void main(void) { // configure USART OpenUSART( USART_TX_INT_OFF & USART_RX_INT_OFF & USART_ASYNCH_MODE & USART_EIGHT_BIT & USART_CONT_RX & USART_BRGH_HIGH,25 ); while(1) { while( ! PORTAbits.RA0 ); //wait for RA0 high WriteUSART( PORTD ); //write value of PORTD if(PORTD == 0x80) // check for termination break; // value } CloseUSART(); } so from what i know is that i need to configure uart receiving (pic).. and im using rs-485 to communicate.. hence theres a rs232 to rs485 converter.. so here's the order hyperterminal > rs232/rs485 converter > rs485 > pic...
hi all... i need to transmit bits from pc to pic... i dont know how to start apart from this code i got hold of Code: #include <p18C452.h> #include <usart.h> void main(void) { // configure USART OpenUSART( USART_TX_INT_OFF & USART_RX_INT_OFF & USART_ASYNCH_MODE & USART_EIGHT_BIT & USART_CONT_RX & USART_BRGH_HIGH,25 ); while(1) { while( ! PORTAbits.RA0 ); //wait for RA0 high WriteUSART( PORTD ); //write value of PORTD if(PORTD == 0x80) // check for termination break; // value } CloseUSART(); } so from what i know is that i need to configure uart receiving (pic).. and im using rs-485 to communicate.. hence theres a rs232 to rs485 converter.. so here's the order hyperterminal > rs232/rs485 converter > rs485 > pic...