Can i find parts to bring this thing back to life?
ANY help would be appreciated
What is not shown is the encapsulated transfo. that has to be unsoldered to get to the component side
Jeebus it's your lucky day first time poster.
I've played with these several times and found my pics. Its mostly the time delay fuse popping and a couple with a flaky micro switch.
This board is simply a dual bridge linear power supply. No reverse engineer diagram so can't remember that voltages but one is for the electronics cpu board an the other provides for the motor.
Your component is a varistor on the primary of the bridge, It is used for surging.
So you either got a bigass surge, and need to check your main board for frying/shorting, or a bridge diode/s shorted and took it out which may have put ac into your main board. I can see from your pics that the fuse took a beating as well.
You need to determine what the damage is.
So, after you verify that the 4 small diodes are not shorted, you can remove the remaining varistor bits for a try without it connected to the rest on the machine to see if'n your voltages are correct and DC.
Then check the input to the board for shorts. If all is well then find a new 14 volt varistor (i think from my zoomed pic). and your done.