transmit data via RF to another PIC

Status
Not open for further replies.

mdanh2002

Member
Hi,

What is an easy way to transmit some bytes (possibly text) from 1 PIC to another wirelessly? I don't need fast speed, perhaps 1200bps or even slower will do. I am trying to find some cheap FM transceiver chips and use them to transmit/receive RS-232 data using the PIC UART module but can't find any.
 
Have a look at nigel goodwins tutorials.
There is a tutorial all about rf comms.

Thanks, I have had a look, but the tutorial does not explicitly specify or recommend which RF modules to use. Any recommendations for cheap modules is appreciated.
 
Thanks, I have had a look, but the tutorial does not explicitly specify or recommend which RF modules to use. Any recommendations for cheap modules is appreciated.

It specifies the ones I used, didn't you check the hardware page?.



But it should work with any similar modules, just check the voltage requirements.
 
Thanks Nigel. I missed your hardware page. I was looking at the tutorial page and download the ZIP file of the tutorials only. Will try to look for these RF modules in my local electronics shop.
 
Last edited:
Hi,

Can I use this module to transfer UART data?

**broken link removed**


Specifications:

* Type: RF radio
* Data rate (max): 10KHz
* Range: 100m (330ft)
* Carrier frequency: 315MHz
* Power supply: 5V - 6V
* Output type: square wave
* TX dimensions: 17 x 13.5mm
* TX pin length: 5.55mm
* RX dimensions: 32 x 14mm
* RX pin length: 7mm
* Brand new and unused
 

It looks to be OK.
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…