Torn trace, SMD, possible to repair?

See the attached images. I tore the lower trace for that little IC. Is there anything that can be done about this?

There is no visible via going to the other side that I can jump a wire to. I even tried digging into the resin of the PCB to see if I could find a small trace to solder onto, but I guess that was a bad idea.

I can not see; but maybe the IC pin goes nowhere.

What kind of board is it? Someone may have one to compare. Pictures on shopjimmy may help. also check datasheet of ic for pinouts.

Actually it is not needed, excellent. Thanks!