i got a project to design a timer that counts from 0.1sec to 99.9 sec, it needs to be done using PIC16F628A in C language and the numbers should be shown on a 3*7 segment display LED, a start stop and reset buttons should also connected to the circuit.
i got little ideas but not sure how to start.......plz help.......thanx
fatty
He meant for googling, the 16F628 was the replacement for the 16F84, so there's a lot of stuff out their for the 16F84 which will work with VERY minor changes for the 16F828.
Your BIG problem is the requirement for C, most code out there is assembler.
But as this is an assignment, then you must have been given enough tutition in class - unless you didn't pay attention?. An assignment is for testing what you know, so it's important that YOU do the assignment, and not cheat by getting help!.
Do you have specific questions? Do you already know how buttons, displays, resistors, etc. are connected to the uC?
Suggestion: don't use floating point variables. You can use only integer ones.
I guess you were taught to multiplex 7-segment LED displays.. You can't write the code if you don't decide the connections.. Do you have a list of parts?? Do you use c.c. or c.a. displays? Are you free to decide?
the project only has a PIC16F628A 3 LEDS, resistors because its suppose to count from 0.1 sec to 99.9sec , connecting 5V to the decimal point it leaves it turned on.
i need the timer to be able to start stop and restart.
the 3 LEDS can be connected, but a program is needed for each 1