Hello everyone,
I'm new to PCB design. I'm currently designing my first 2-layer board. I have digital output signals having a frequency ranging from 50 to 100 MHz that I would like to probe. What is the best test point strategy to not loose the shape of my signal ?
Are surface mount test point good for that ? (for example: https://www.keyelco.com/products/prod43.asp?SubCategoryID=113)
Is it better to use a via without solder mask on it and solder a wire to probe on it ?
Thanks a lot for your help !
I'm new to PCB design. I'm currently designing my first 2-layer board. I have digital output signals having a frequency ranging from 50 to 100 MHz that I would like to probe. What is the best test point strategy to not loose the shape of my signal ?
Are surface mount test point good for that ? (for example: https://www.keyelco.com/products/prod43.asp?SubCategoryID=113)
Is it better to use a via without solder mask on it and solder a wire to probe on it ?
Thanks a lot for your help !