Temperature Sensor Design using DS18B20. Need Help!

Status
Not open for further replies.
J

Jellie7r

New Member
i have to design a temperature sensor using DS18B20 and PIC 18F452.
DS18B20 is a temperature sensor that outputs in digital bits. how do i recognize the bits through the PIC and output it to the PC using RS232 serial port. I am new at this and not sure how the programming works...really need help!! i have a rough ciruit layout already but am stuck there.

Appreciate it. Thanks.
 
I have used DS18B20 recently, and is easy to interface and has nice accuracy.
It is using Dallas 1wire bus, where bits are recognized by the High/Low ratio.
It's a slow, half-duplex serial open collector bus, so only 1 pin of 452 will be used (particulary RA4 -open collector pin).
As for programing, everything is included in DS1820 datasheet, it shouldn't be a problem for writting a small program...
 

Didn't you start this thread in another discussion?
Post your schematic in order to get the best feedback.
 
Status
Not open for further replies.

Similar threads

G
  • Question
My son need help with his circuit design!!!
Replies
14
Views
1K
ZipZapOuch
F
how should you design milliohm meter using dvm display
2 3 4
Replies
73
Views
12K
Flashdrive34
F
F
  • Question
Need to design and build 250W BLDC inverters for drones
Replies
2
Views
1K
Papabravo
A
  • Question
Rookie needs help with keypad circuit design
Replies
11
Views
3K
ac-dc
A
B
  • Question
Game Laser Sensor
2
Replies
21
Views
2K
Tony Stewart
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…