Taping into painted ribbon with solder-abl ribbon cable

https://www.electro-tech-online.com/threads/comparator-behavior-with-high-impedance-input.2972/
I Ben searching high and low for a part to no avail. New direction idea. Can I jump this painted ribbon cable with a ribbon I can solder a new end?

Do you mean that you want to replace the painted ribbon cable with wire ribbon cable? Typical wire ribbon has 100 mil spacing, so it should be able to fit in the holes that the socket was in.

I can't replace all the painted ribbon because it is a whole membrain. I just want to tap into it and solder new end. What connection to use? I see in my computer for hard drive the ribbon it has and can be done on my project.

Silver conductive epoxy or similar is what you need. Check out Digikey part number: CW2900-ND, which is for flexable traces. The cost is $20 but it should do the job.

Sorry, if you misunderstood me I need a new end connector not a new membrane. That product will not work thanks for help. I don't know what its called when you meet two ribbons my old painted ribbon to new hard wired ribbon that I can put a new end connector on. Please refer to original topic when I was looking for a special connector for painted ribbon cables like mine. Thanks again for any and all help.