well, I need to get a better voltmeter, as the one I have has some LED s that mark 11,12,13 volts, thats it.
it shows up in the 11 led, but it flickeres some, like its not really 11...
yes, i mean the remote signal, thanks Exo. its atached to the same acc. power that goes to the stock radio its self. I think that this means their isnt enough power to keep the amp on fully, so it is popping and such at low volumes, but the popping goes away when i crank it up some.
so, i thought i would use the large heavy power cable, with a little split off, to power the remote line. so, i need a switch or something to open and close that, so it turns off with my truck. So, I thought I could use the acc. line that i already had installed, to activate it. or put a transistor to ramp the voltage some, or something.
I appreciate the prompt help folks, thanks