Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Im having a problem with a 10f200 chip in that it works perfect on power up, but if i disconnect the power and reconnect it say within 5 seconds it activates a GPIO outout for no reason and seems unable to turn it off.
any thoughts? is it just a consequence of 'brown out'?
Im using GP3 as an input pin and as far as I can tell that should activate the internal POR?
the power is being removed completly(by me disconnecting the wire at the moment) and any residual should be used by an LED in parallel.
thats just the start of the program, after that I await the press of a switch then do other stuff, but essentially after I reapply power it activates an output regardless of if it was on beforehand or if the switch is pressed.
as I say im new to this really, im a VB programmer normally so by all means im probably not doing something right
but as I say the program works flawlessly on a fresh power up from cold
Ive now edited the code to how I have it now....but same issue.