mramos1
Active Member
I just bought some Tiny11 ship, was so excited. Ported a program over to it. Got out the manual and find it is Serial High Voltage programming. Assume that is 12V on it. Anyway. I jumpered the board per the manual and no go.
Running 3.55 of the AVR software, pulled 4.0 to try tonight. Anyone think of something obvious? Or have a simple Tiny11 programmer. I have looked at two, but figure I own a $$$ one.. Like to use it.
Can can not read the signature on the chip, it defaults to disable future programming on the chip.. I do 2313, 1200 and mega8 all the time with parallel high voltage.
Running 3.55 of the AVR software, pulled 4.0 to try tonight. Anyone think of something obvious? Or have a simple Tiny11 programmer. I have looked at two, but figure I own a $$$ one.. Like to use it.
Can can not read the signature on the chip, it defaults to disable future programming on the chip.. I do 2313, 1200 and mega8 all the time with parallel high voltage.