Stepper Motor with MATLAB GUI and Arduino

Status
Not open for further replies.

Pankaj Khatri

New Member
can anyone tell me how to control stepper motor with Arduino and MATLAB GUI... and is there is any library for stepper motor for MATLAB.
 
You need some kind of stepper shield and write code or use a library.

Mike.
 
thank you all.. i found the solution.. there is no need of library if you are controlling the direction of the stepper motor or any other task,
with GUI you just have to use the toggle button and use a while loop and ON or OFF the stepper inputs according to the movement
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…