stepdown transformer

Status
Not open for further replies.
J

jjac7212

New Member
Hey guys, im from australia and am trying to build an american guitar amp
anyway i have a problem with the transformer and just needed to know two things. one is that my local store sells a good transformer that gives pretty decent compatibility with the circuit in terms of voltage, it takes the 240 volt aus power. the two bottom taps are 15v and i need a 5v and a 6.3v for these, so how would i calculate the right resistors for these taps to connect to, to bring the voltage down to the right value?
secondly, would it be easy for a noob like myself to wire up a transformer myself? im trying to save a little money and get the voltages closer.
 
It looks that you have a valve amplifier with 6.3 volts ac for the heaters.

Normally they are fed from a dedicated 6.3 Volts ac winding of the TX.

You can use a 5 Volts regulator (7805 or 7805 + 2 diodes in series on the negative to get 6.2 volts, for the valves, or an LM 317 and set it for 5 volts or 6.3 volts but it would be very inefficient.
E.G. 1 Amp at 15 - 6.3 Volts 8.7 volts = 8.7 watts dissipated in heat.

It is better to have for the valves a dedicated 6.3 volts ac winding.

Also a transformer gives ac which you will need to rectify to dc via a bridge rectifier, and filter capacitor.
 

It sounds like your transformer is totally unsuitable, any valve transformer is likely to include a 6.3A winding, so what is the transformer designed for?.

Assuming the rest of the transformer is OK?, then simply use a separate heater transformer for the 6.3V.
 
Valve amp ?

Where do you need 5 volts for in a valve amplifier ?

I was pondering about that one over the last hour.

Normally 6.3 volts for the heaters and a HV winding (± 200 Volts ac) for your HV dc to supply the 350 V dc for the valves.

Regards from across the ditch, Raymond
 
RODALCO said:
Where do you need 5 volts for in a valve amplifier ?
Click to expand...

Some really old valves used 5V heaters, but it sounds a bit unlikely in this day and age?.
 
JJ
Just in case you have not yet made up your mind look at . They have lots of little guitar amps schematics (mainly from the 60's 3 and 4 valve jobs. Some very simple and also some very sophisticated ones
Also https://www.vintage-radio.net/ is a very helpful website when it comes to valve type amps, if you are having problems.

Cheers RH
 
Status
Not open for further replies.

Similar threads

D
  • Question
voltage stepdown chip and diode location
2 3
Replies
47
Views
6K
Dave001
D
C
  • Question
StepDown Buck Question
Replies
4
Views
3K
christinescoms
C
D
  • Question
Transformer from air conditioner
Replies
2
Views
1K
Les Jones
L
B
  • Question
Transformer Power Output Mystery
Replies
12
Views
2K
briesmith
B
C
  • Solved
Which transformer project?
Replies
4
Views
1K
Cgbalderrama
C
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…