I am using an ATMEGA 328 in stand alone mode. Here is my problem:
I programmed my pic using arduino uno, then removed the chip and built my own circuit (pic+2caps+crystal+resistors).
When I power my system the code that I uploaded doesn't do its job so I have to reprogram the pic again. However when I use it with a small code such as the blinking LED it does work; every time I turn the power on the LED that I set to blink blinks according to the the time I set. Could you please provide some feedback on this. Why the program doesn't stay in the pic when you power the system again.
Thanks
I programmed my pic using arduino uno, then removed the chip and built my own circuit (pic+2caps+crystal+resistors).
When I power my system the code that I uploaded doesn't do its job so I have to reprogram the pic again. However when I use it with a small code such as the blinking LED it does work; every time I turn the power on the LED that I set to blink blinks according to the the time I set. Could you please provide some feedback on this. Why the program doesn't stay in the pic when you power the system again.
Thanks