How the professionals do it?
Given a certain spec (like for the LM 337):
Min I load : typical 2,5 mA - max 10 mA
Should I calculate my circuit for those 10 mA? Or hope it is 2,5 mA?
Please note that my question is not about the regulator but about how a correct design should be done.
Given a certain spec (like for the LM 337):
Min I load : typical 2,5 mA - max 10 mA
Should I calculate my circuit for those 10 mA? Or hope it is 2,5 mA?
Please note that my question is not about the regulator but about how a correct design should be done.