simulating an LM386 circuit

Status
Not open for further replies.

MrDEB

Well-Known Member
Found the file for SPICE but inserting into the LTSPICE program?
here is the circuit I am trying to figure out WHY I can hear 28khz sounds.
Using a 9v 200ma wall wart. When I used a 9v battery I couldn't hear any sound. Figure it must be V= related. When I change the input square wave to under 12khz I can hear the tone very well but above 12khz it sounds like its underwater.
Using a PIC to output the square wave.
here is the schematic as well. I used slightly different caps but ?
 

Attachments

  • lm386 bat amp.png
    19.2 KB · Views: 534
  • bat circuit2.png
    34 KB · Views: 462
C5 and C6
Maybe need more?
I think c5 is 10uf elect and c6 is 1uf but would need to take unit apart again.
Plan is to use as is, build another unit and try again with different/ more PS caps.
You might be on to the solution. Never occurred to me.The PCboard didn't come out as planned, started having traces lift from the board. Thinking I got the board too warm when I laminated the toner transfer on.
 

Only the left hand graphic was there when I replied - but instability on IC amplifiers is common if the layout isn't good, and in particular close decoupling is a major help.
 
Am redoing the board with closer cap/Vdd,Vcc connections.
also larger caps perhaps.
Thinking of adding one on the LM3856 pins 6 & 4.
 
MrDEB said:
Am redoing the board with closer cap/Vdd,Vcc connections.
also larger caps perhaps.
Thinking of adding one on the LM3856 pins 6 & 4.
Click to expand...

You should do so - I'm presuming the main decoupler is also a substantial size?.
 
I used what I have but going to rebuild using a 10uf elect. on the 7805 input to ground sand .01 on the 7805 output to ground.
Adding a .01 across the amp power pins (6 & 4)
I feel the PCboard i made was not real good in the layout department. Caps too far away from pins and some raised traces (I think i got the board too hot when laminating. First time for everything.
 
MrDEB said:
I used what I have but going to rebuild using a 10uf elect. on the 7805 input to ground sand .01 on the 7805 output to ground.
Click to expand...

10uF is FAR too low, I would suggest at least 470uF, and possibly 2200uF (not for the 7805, but for the LM386).
 
Status
Not open for further replies.

Similar threads

E
  • Question
Issues Simulating Duffing Oscillator In LTSpice
Replies
3
Views
3K
Tony Stewart
Simulating a shaft.
Replies
6
Views
2K
Lightium
M
  • Question
help identify a component on a microphone circuit
Replies
11
Views
1K
Nigel Goodwin
P
  • Question
Recommend a simulator software for students that has all the components present in the circuit diagram
Replies
3
Views
1K
danadak
H
  • Question
GNSS Receiver designed IC circuit noise issues
Replies
12
Views
2K
rjenkinsgb
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…