Simple question.

Voltboy

New Member

• Nov 1, 2007

• #1

Hello.
I'm kinda new at electronics, and I order a microcontroller and I'm wait to arrive.
But I have a question. After I program the microcontroller how I do to make it work, I mean, to make it run the program when its already on the breadbord (or PCB or whatever), do I simply connect both +V and GND pins and its start executing the program?

 

bananasiong

New Member

• Nov 1, 2007

• #2

Yes, but remember the pull up the MCLR (Master Clear) pin so that it won't be floating and keeps reseting.

 

Voltboy

New Member

• Nov 1, 2007

• #3

so how exactly to put the pull up?

 

donniedj

Banned

• Nov 1, 2007

• #4

Such information should be covered from
The best e-book
AAC

 

raskopi

New Member

• Nov 2, 2007

• #5

where can i find an e-book about that

 

Gayan Soyza

Active Member

• Nov 2, 2007

• #6

May be this site will be useful.

http://www.talkingelectronics.com/te_interactive_index.html

 

Attachments

• Expt1Cct.gif

  4.8 KB · Views: 127