Simple question.

[Voltboy]

Hello.
I'm kinda new at electronics, and I order a microcontroller and I'm wait to arrive.
But I have a question. After I program the microcontroller how I do to make it work, I mean, to make it run the program when its already on the breadbord (or PCB or whatever), do I simply connect both +V and GND pins and its start executing the program?

 

[bananasiong]

Yes, but remember the pull up the MCLR (Master Clear) pin so that it won't be floating and keeps reseting.

 

[Voltboy]

so how exactly to put the pull up?

 

[donniedj]

Such information should be covered from
The best e-book
AAC

 

[raskopi]

where can i find an e-book about that

 

[Gayan Soyza]

May be this site will be useful.

http://www.talkingelectronics.com/te_interactive_index.html