Hi,
i send the sensor data to RF transmitter with serial communication(1-wire) then on the reciever board
RF reciever get the data and send it to the micro by serial comunication and show it on lcd.
i should send the sensor data every 5 minutes and during this time micro goes to sleep mode.
after two or three transfering , i can't see anything on lcd but after restarting the micro
it works without any problem.
why do you think after 2 or 3 transfering this problem is occuring?
how can i solve the problem?
is it about software?
i use microcode sudio picbasic pro2.41 .
i use serin and serout instructions for serial communication.
i send the sensor data to RF transmitter with serial communication(1-wire) then on the reciever board
RF reciever get the data and send it to the micro by serial comunication and show it on lcd.
i should send the sensor data every 5 minutes and during this time micro goes to sleep mode.
after two or three transfering , i can't see anything on lcd but after restarting the micro
it works without any problem.
why do you think after 2 or 3 transfering this problem is occuring?
how can i solve the problem?
is it about software?
i use microcode sudio picbasic pro2.41 .
i use serin and serout instructions for serial communication.