Trippple P
New Member
Hello you all, so far i'm glad i found that site.
I have a big project...
I would like to use a DC motor from a Fork lift to replaced a 8 hp gas engine(
I beleive it is a Brigg &... on a "special" post hole digger drill it need to reverse. I'm thinking about a Dc motor because of it hi torque and "ease" to control the rotation.
My first question is what size of motor that would be?
I thought utiluse a 24-volt motor because my ac welder can produce a constant source of about 90A @ 25 volts. Saying that if any one got a SCR bridge schematic on hand that could be nice.
I know i have to do more home work, that i a new idea who came in a couple of days ago.
I thanks' everyone in advance.
P.S. I'm a french canadian so please forgive the translation...
I have a big project...
I would like to use a DC motor from a Fork lift to replaced a 8 hp gas engine(
I beleive it is a Brigg &... on a "special" post hole digger drill it need to reverse. I'm thinking about a Dc motor because of it hi torque and "ease" to control the rotation.
My first question is what size of motor that would be?
I thought utiluse a 24-volt motor because my ac welder can produce a constant source of about 90A @ 25 volts. Saying that if any one got a SCR bridge schematic on hand that could be nice.
I know i have to do more home work, that i a new idea who came in a couple of days ago.
I thanks' everyone in advance.
P.S. I'm a french canadian so please forgive the translation...