'Scope tube anode cap needed!

The anode cap of my Cossor CDU 150 has melted. Does anyone have a small CRT anode cap I can use as a replacement?
Thanks!

I just happen to have a dead 9" crt monitor in my living room* at the moment, the LOPT is shot so you are welcome to the lead/cap if it's the correct one.

What diameter is the "pin" on the existing connector - or do you just need the insulating boot?

[* - Single, Engineer, lifelong electronics and computer enthusiast..]

rjenkinsgb said:

dead 9" crt monitor in my living room

Click to expand...

rjenkinsgb said:

Single, Engineer

Click to expand...

I just heard "two dead oscilloscopes on the kitchen table??? You three out of here."

ronsimpson said:

"two dead oscilloscopes on the kitchen table???

Click to expand...

Not exactly.. A monitor from a CNC machine and a 3D printer, on the dining table..
(The dead scope is in the garage; parts for its working twin).

Hello there rjenkinsgp. It's just the boot I need, I can alter it slightly if needs be. Clip is about 3/8" I think. Anode voltage is only about 9kV so your one would probably be about right. I'll PM you to arrange something. Many thanks!
What's really annoying is I had 2 from old computer monitors a few years ago, kept the lopts and threw the caps away! IMA dumbass...