I'm trying to fix my roland space echo. The reverb stopped working. I'm trying to poke around with my multimeter set on continuity, but i've just recently started trying to learn electronics and i'm limited with reading schematics.
In the space echo schematics that i've attached, i first can't figure out which end of the reverb unit (outlined in RED) is IN and which is OUT. I've connected one of the multimeter probes to the IN (or OUT... again, not sure which is which) RCA cable of the reverb. Using the schematics i can see there is a connection at point #33, so i'm following the path and i'm not getting continuity after the component that i outlined in blue. Not sure if there should even be continuity.
Can someone point me in the right direction?
i color coded the connection points on the reverb. Hopefully someone can tell me which is which. hopefully i've supplied enough info.
Thanks!
**broken link removed**
In the space echo schematics that i've attached, i first can't figure out which end of the reverb unit (outlined in RED) is IN and which is OUT. I've connected one of the multimeter probes to the IN (or OUT... again, not sure which is which) RCA cable of the reverb. Using the schematics i can see there is a connection at point #33, so i'm following the path and i'm not getting continuity after the component that i outlined in blue. Not sure if there should even be continuity.
Can someone point me in the right direction?
i color coded the connection points on the reverb. Hopefully someone can tell me which is which. hopefully i've supplied enough info.
Thanks!
**broken link removed**