hostilehitman
New Member
Sorry for using links to the images. They're too large to upload here.
I have an iPV4S mod and one of the battery contacts pops out whenever slight pressure is applied to it, as seen here: i.imgur.com/aUsdLg8.jpg
Here's a view from inside: i.imgur.com/NAuGI8E.jpg
It's easy to pop it back in place as shown here: i.imgur.com/PF1EahM.jpg
Although it's easy to put back in place, putting the battery in just pushes it right back out. I need a way to permanently secure it but super glue is too weak. I thought about using epoxy but I'm not sure which brand is safe for electronics, if any. I don't want this thing taking off my hand in an explosion so I'm trying to be safe. If epoxy is the way to go can anyone recommend a specific product to use? Perhaps there's an even better way? Thank you for any advice y'all can give!
I have an iPV4S mod and one of the battery contacts pops out whenever slight pressure is applied to it, as seen here: i.imgur.com/aUsdLg8.jpg
Here's a view from inside: i.imgur.com/NAuGI8E.jpg
It's easy to pop it back in place as shown here: i.imgur.com/PF1EahM.jpg
Although it's easy to put back in place, putting the battery in just pushes it right back out. I need a way to permanently secure it but super glue is too weak. I thought about using epoxy but I'm not sure which brand is safe for electronics, if any. I don't want this thing taking off my hand in an explosion so I'm trying to be safe. If epoxy is the way to go can anyone recommend a specific product to use? Perhaps there's an even better way? Thank you for any advice y'all can give!