Peter_wadley
New Member
Well as the name states.. im trying to fine tune my assembly code for running a S3003 standard servo..
I really dont understand how the servo is to be controlled..
When I send the command line a Square wave with a 0/1 frequency it turns Counter Clockwise.. the higher the frequecy the fast it turns..
When I get over a certain frequency.. it goes the other way..
Is this how you control it?
I cant seem to find out the correct Delay time.. for each way..
The google tutorials arent really explaining this very well..
Here is the servo specs: **broken link removed**
Thanks
I really dont understand how the servo is to be controlled..
When I send the command line a Square wave with a 0/1 frequency it turns Counter Clockwise.. the higher the frequecy the fast it turns..
When I get over a certain frequency.. it goes the other way..
Is this how you control it?
I cant seem to find out the correct Delay time.. for each way..
The google tutorials arent really explaining this very well..
Here is the servo specs: **broken link removed**
Thanks