Hello,
I'm attempting to connect a device (syringe pump) to my computer. The device itself is pretty old, so the original cable was lost at some point. I've tried looking for a new cable but with no success. I've also tried to search the web (for ~3 hours) to find an adapter or a schematics of such an adapter, so now I decided to do the adapter myself (with your generous and much appreciated help. Where do you recommend me to start the design stage? Any thoughts on the matter?
In general, the device address is set to 0 and the baud rate can be-- 300, 1200, 2400, 4800, or 9600.
Attached the pin out of the RJ 9 of the syringe pump and the standard pin out of RS 232.
Thank you,
Simply
I'm attempting to connect a device (syringe pump) to my computer. The device itself is pretty old, so the original cable was lost at some point. I've tried looking for a new cable but with no success. I've also tried to search the web (for ~3 hours) to find an adapter or a schematics of such an adapter, so now I decided to do the adapter myself (with your generous and much appreciated help. Where do you recommend me to start the design stage? Any thoughts on the matter?
In general, the device address is set to 0 and the baud rate can be-- 300, 1200, 2400, 4800, or 9600.
Attached the pin out of the RJ 9 of the syringe pump and the standard pin out of RS 232.
Thank you,
Simply
Attachments
Last edited: