I bought a RioRand power supply to run this 12vdc-2.3amp gearmotor (https://www.filastruder.com/products/gearmotor). However, the RioRand requires a load greater than 2 Ohms, otherwise it will blow a fuse, and my gearmotor only measures at .9 Ohms across the windings/terminals. I tried putting a fairly large resistor in line between the PSU and one motor terminal and the resistor burnt up in a split second. Is there a simple way to make this work?
https://www.amazon.com/RioRand-Driv...vernor/dp/B00HUQY9HC/ref=cm_cr_pr_product_top
https://www.amazon.com/RioRand-Driv...vernor/dp/B00HUQY9HC/ref=cm_cr_pr_product_top