Hello everyone,
I am quite new to PIC's, so please bear with me.
What I am trying to do is this.
I can read an RFID token 125Khz EM4100 and see the ID using an ID12, into notepad.
What I want to do is output a data string from say, PortA bit 0 on 16f628 ie emulate a token.
I will then feed this into a door controller's signal input.
My PIC needs to run at 4Mhz
Any help will be greatly appreciated.
I am quite new to PIC's, so please bear with me.
What I am trying to do is this.
I can read an RFID token 125Khz EM4100 and see the ID using an ID12, into notepad.
What I want to do is output a data string from say, PortA bit 0 on 16f628 ie emulate a token.
I will then feed this into a door controller's signal input.
My PIC needs to run at 4Mhz
Any help will be greatly appreciated.