MrDEB
Well-Known Member
I have been revising this simple circuit several times. I posted about transistor switches so I made some changes
when 4030 goes low 2n3906 turns on enabling the DPDT relays
DPDT relays are not activated until a Monentary pushbutton is depressed. The DPDT relays are latched upon activaction and will only allow one red light on (first one pressed)
the pushbuttons are debounced w/ the 100uf cap in parelle w/ resistor (should be 3.3K resistors to form voltage divider = 12V)
when pushbutton is pressed the FET transistors are turned on w/ 6v (junction of the 4K voltage dividers.
the 24v divider/ switch debouncer RC network is located 15feet from the pushbuttons and relays.
FETs are near the pushbuttons. 50 feet from pushbuttons to solenoids
Does this sound feasiable?
when 4030 goes low 2n3906 turns on enabling the DPDT relays
DPDT relays are not activated until a Monentary pushbutton is depressed. The DPDT relays are latched upon activaction and will only allow one red light on (first one pressed)
the pushbuttons are debounced w/ the 100uf cap in parelle w/ resistor (should be 3.3K resistors to form voltage divider = 12V)
when pushbutton is pressed the FET transistors are turned on w/ 6v (junction of the 4K voltage dividers.
the 24v divider/ switch debouncer RC network is located 15feet from the pushbuttons and relays.
FETs are near the pushbuttons. 50 feet from pushbuttons to solenoids
Does this sound feasiable?