this is a simple circuit yet as it uses 220 ac volts i'm think the smart thing is to ask experts if there is anything wrong with it before plugging it in
i've a laser sensor with a relay that switches off if the beam isn't recieved
a timer relay (delay on) which i use to turn the circuit on for certain amount of time
a contactor which i use to first drive the load and second to latch the timer on for
as long as the delay as cause the laser sensor only give me pulse
please review my design and let me know if anything will go wrong
Hi Andrew,
I can't see anything wrong with the hand drawn schematic. I don't know if the schematic on the squared paper is related to the question. RLY3 and RLY1 have their coils connected in series . Also you would need special relays to work from a 1KHz power supply. The reactance of relays designed for 50/60 Hz would be much higher at 1 KHz so they would probably not work.
Hi Andrew,
I can't see anything wrong with the hand drawn schematic. I don't know if the schematic on the squared paper is related to the question. RLY3 and RLY1 have their coils connected in series . Also you would need special relays to work from a 1KHz power supply. The reactance of relays designed for 50/60 Hz would be much higher at 1 KHz so they would probably not work.
it's not 1k i just forgot to edit it, and idk why i'm doubting myself but my point is, it's expensive components with high voltage so it's why i'm triple checking