Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Resistors to stop shorts?

Status
Not open for further replies.

Screech

New Member
Must you always use a resistor between most ic's out pin and a transistor?
Eg:pin 3 of 555 to an npn transistor.

Say I need 200 milliamps going to base of tansistor mj150013.
The 555's output can supply 200 milliamps.

Can I run the 555's output to the transistor without a resistor?
Will that cause the ic to short (as current flows from base to emitter(earth)).

does the tranny act as a load from base to emitter?
Think I'm going on and on.

Thanks
 
Resistors to stop shorts

Yes, you need a resistor in order to limit the base current to a safe level.

What collector current do you want? The base current only needs to be about one tenth of the collector current in order to saturate the transistor.

200mA seems a bit much. I don't know whether the 555 can source this much.

Len
 
Yes, you need a current limiting resistor - otherwise you are effectively connecting the base emitter junction of the transistor straight across the supply rails - shorting them together.
 
That transistor is a 5 amp one.
Its hFE is 25

so 5000mA/25 =200mAmps.

I only nead 4amps:
4000/25=160milliamps
so I'm going to supply it with a bit more then 160milliamps, with a resistor.

Thanks for answering my question guys.
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top