Hi,
I am running design rule checks, and when i do , certain nodes report "unrouted net" problems.
The track doesnt quite go to the middle of the pad or via.
So then i correct it, and re-run the design rule check, and low and behold, one of the nodes again
has "Unrouted net" problem, and the editted correction that i had just put in has somehow just not happened.
Even though i save the whole project every time that i do a correction.
I am literally just going round and round in circles.
Do you know whats wrong?
(Altium 23)
I am running design rule checks, and when i do , certain nodes report "unrouted net" problems.
The track doesnt quite go to the middle of the pad or via.
So then i correct it, and re-run the design rule check, and low and behold, one of the nodes again
has "Unrouted net" problem, and the editted correction that i had just put in has somehow just not happened.
Even though i save the whole project every time that i do a correction.
I am literally just going round and round in circles.
Do you know whats wrong?
(Altium 23)
