Hey.
My MCU transmits and receives information wirelessly.
Currently, its sensistivity is configured to -91.
Its possible to upgrade it to -92 (it just will take some time to unpack the units, burn the code and pack it up again).
So, until i'll have this test, i wanted to ask you if theoretically there should be a difference in the reception range due to this upgrade and in the "qualitiy" of the network (meaning experiencing less momentary disconnections due to loss of packets).
For example, when I increased the TX output power by 1dBm (from -0.4dBm to 0.6dBm) i noticed the improvement.
Thank you.
My MCU transmits and receives information wirelessly.
Currently, its sensistivity is configured to -91.
Its possible to upgrade it to -92 (it just will take some time to unpack the units, burn the code and pack it up again).
So, until i'll have this test, i wanted to ask you if theoretically there should be a difference in the reception range due to this upgrade and in the "qualitiy" of the network (meaning experiencing less momentary disconnections due to loss of packets).
For example, when I increased the TX output power by 1dBm (from -0.4dBm to 0.6dBm) i noticed the improvement.
Thank you.
Last edited: