Proteus simulation-Multimeter

Status
Not open for further replies.
M

marius9612

New Member
Hi, I have to do the drawings in the drawing in Proteus, but I do not succeed, I do not understand something. You can help me.Thanks.
 
Wow... A bit of a mess.... I doubt anyone can help on this information.. You are going to have to do the drawings in paint then explain some of your symbols... I don't recognise them..

Moved to homework help!!
 
6k and 1k doesn't make 1/8th...

Power divider? Do you mean regulator 20v -> 5v..
 
Then the current in the "voltage divider" will differ from circuit to circuit... Hence so will the voltage... To get 5V from 20 and keep the same ratio's you'll need a regulator or at least a Zener!
 
marius9612 said:
yes those that I did give them that is, but it is the one above in the first drawing, I was referring to it
Click to expand...

Well it's impossible to tell anything from the first drawing, it's looks mostly like a spider has just crawled through a blob of ink
 
Status
Not open for further replies.

Similar threads

I
  • Question
How to create a printer in Proteus 8
Replies
0
Views
5K
Ivor
I
A
Making an Avometer "multimeter" (AC & DC) with some filters
Replies
7
Views
3K
danadak
G
proteus 741 op amp current to voltage help
2
Replies
38
Views
10K
audioguru
J
Need a favor from someone with licensed Proteus 8
Replies
2
Views
3K
JordanV
J
C
I have to design an audio preamplifier as a project, need help with OrCad simulation
Replies
4
Views
3K
audioguru
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…