protection from parellel printer port

Status
Not open for further replies.
J

jaikanth

New Member
:cry:
i'm doing jamming program in flash ic (target board) through a jamming device which connected in printer port.(25 pin)
is there any protection circuit that can control the voltage flow in my printer port cable below 5v and 63mA.
mostly my jamming device(which is going to program in flash)gone bad.
simply i need a buffer circuit for parellel printer port.
 

Parallel port programmers usually use 7407 or 7406 open-collector buffers, these give you the capability to switch higher voltage supply rails (via PNP transistors) and also protect the port. There's nothing going to provide total protection, particularly if you do something stupid, but buffer chips provide a reasonable amount of protection at low cost.
 
Status
Not open for further replies.

Similar threads

N
  • Question
6V 3W bicycle hub alternator to Phone's 5V charging port
Replies
6
Views
1K
Tony Stewart
D
  • Question
Transformer from air conditioner
Replies
2
Views
1K
Les Jones
L
F
  • Question
Making a sinusoidal power waveform from two halves?
Replies
9
Views
1K
ZipZapOuch
Simple Overvoltage Protection
Replies
11
Views
2K
Kerim
O
  • Question
Reading Digital + Analog Data from Sensors / Bus
2
Replies
26
Views
3K
Tony Stewart
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…