amelecsol2000
New Member
Hello to all,
I am working on an " MA Audio " high power audio amp. Model #HK401SX .
The protection circuit is triggered. I can't get a service manual for this unit.
Pins 9 & 10 on the (PWM " TL494CN ") Bias the mosfets , should get 5VDC on each, I have 0VDC on these pins . All of the other pins read normal VDC including the oscillator output. I replaced the PWM with another but have the same results . Seeing as the other pins are normal the PWM should be faulty but that is not the case ???
Anyone have any sugestions or advice ? It sure would be appreciated !!!
PS. all of the mosfets test good.
I am working on an " MA Audio " high power audio amp. Model #HK401SX .
The protection circuit is triggered. I can't get a service manual for this unit.
Pins 9 & 10 on the (PWM " TL494CN ") Bias the mosfets , should get 5VDC on each, I have 0VDC on these pins . All of the other pins read normal VDC including the oscillator output. I replaced the PWM with another but have the same results . Seeing as the other pins are normal the PWM should be faulty but that is not the case ???
Anyone have any sugestions or advice ? It sure would be appreciated !!!
PS. all of the mosfets test good.