I am using an lm3914 in dot mode with 8 leds connected (which means outputs 9 and 10 are left open).
In dot mode I have an issue where the top led (led8) seems to be dimly lit. I had the same issue with led1 but I fixed this by using a 10k resistor connected across it.
If I switch to bar mode then the top led is no longer dimly lit.
Also I am using high efficiency leds.
Any tips?
In dot mode I have an issue where the top led (led8) seems to be dimly lit. I had the same issue with led1 but I fixed this by using a 10k resistor connected across it.
If I switch to bar mode then the top led is no longer dimly lit.
Also I am using high efficiency leds.
Any tips?