I don’t know how the component are connected in this power supply please any one help me to understand how the component are connected
This PCB contain two circuit
Power supply
Programmer circuit
I have attached image
Power supply circuit component
12v battery connected to battery connector . battery connector connected to on/off switch. On / off switch connected to bridge rectifier IC w104br , after rectifier IC don’t know which one capacitor c10 or c13 connected to the output of rectifier and voltage regulator IC 7085 connected to output of filter capacitor
First I don’t know which one is one capacitor is connected C10 or C13?
actually I searched for power supply and I got this Image I wantto make power supply myself In this circuit I don't know which one capacitor is connected first I want to make layout first after that I want to soldering on PCB
I wantto make power supply myself In this circuit I don't know which one capacitor is connected first I want to make layout first after that I want to soldering on PCB
check out this its paper work
12v dc battery +battery connector+bridge IC+ capacitor+voltage regulator IC+capacitor+variable resistor+jumper (5 volt for controller+ 5v for programmer circuit )+reset switch+current limiting resistor +LED indicator
paper works means basic idea for power supply design, before soldering component I have done some work on paper now I want to do this on PCB . I just want to conform I made the design is correct or not, ?
hello again , I need power supply circuit for micro controller and sensor circuit. I have 12v dc battery and I need 5v for micro controller and 5v for sensor circuit
component
battery- 12v dc
battery connector
switch- on/off
bridge Ic- 2w10G
C1 capacitor- 1000/25 volt Electrolytic Capacitors
C2capacitor - 22 pf/50 volt Ceramic Capacitors
regulator Ic-708 5v/1amp
C3 capacitor - 22 pf/25 volt Ceramic Capacitors
R1 variable resistor
reset switch
jumper J1
jumper J2
R2fixed resistor
indicator - LED
I have attached Image
J1 and J2 are jumper J1 is used for micro controllers supply and J2 is used for sensor supply . variable resistor is used adjust the resistance.
see post #1 I am trying to make that type of power supply