I am using a 78L05 (UA78L05ACLP). Looked for this info on that datasheet but am thinking it is expected that people reading it would already know. No there.
The test circuit is simple a .33uF cap on the input and a .1uF on the output. Simple enough.
Currently I have 1.0uF and .22uF electrolytic caps but no .33uF except for SMT 1210 ceramic parts. Would rather not use the SMT 1210s for this.
What impact would there be if I used the 1.0uF.
I am thinking none. Am I right that 3x is close enough?
Peeked at where he has a .1uF on the input side where the datasheet shows a .33uF for a LM7805CT regulator. Would that be better ?
The test circuit is simple a .33uF cap on the input and a .1uF on the output. Simple enough.
Currently I have 1.0uF and .22uF electrolytic caps but no .33uF except for SMT 1210 ceramic parts. Would rather not use the SMT 1210s for this.
What impact would there be if I used the 1.0uF.
I am thinking none. Am I right that 3x is close enough?
Peeked at where he has a .1uF on the input side where the datasheet shows a .33uF for a LM7805CT regulator. Would that be better ?
Last edited: