Maybe I was not clear, some of the standby voltages are NOT present. I was tracing through the board and it looks like the bridge, and main part of the PSU is not active until the relay fires over. That being said, if the "standby" voltages should be on as soon as the board is plugged into power, there is certainly something wrong with the board. I guess it is "somewhat" easier to trouble shoot since about 90% of the PSU is dead until the relay is fired so tracing is somewhat easier. That being said, I am still trying to figure out how AC power is being conditioned for the standby outputs. I DO have the 5V out but that is it. All my transformers, power caps, bridge, etc are all dead without the relay switching.
I was just hoping to find someone that has experience in troubleshooting to say "yeah, if the standbys are missing, there is an issue with the board". Or, maybe there is still some type of switching circuit here to turn on these standby voltages.