Hi folks.
I'm building a plasma cutter... (I know, I'm a fool ain't I?! )
But here my question comes (I've already searched trough the forum)
The 300VDC is gonna be pulsed trough a transformer, that is able to handle 3kW.
Prim: 300VDC pulsed - around 10 Amps
Sec: 100VDC or so, which is rectified, and filter trough capacitors. Able of outputting 30 amps.
But does the frequency have any thing to say in this?
Anyone, know any transformer design programs, or know where to buy one? Pref, ebay
Thanks in advance.
Christian.
I'm building a plasma cutter... (I know, I'm a fool ain't I?! )
But here my question comes (I've already searched trough the forum)
The 300VDC is gonna be pulsed trough a transformer, that is able to handle 3kW.
Prim: 300VDC pulsed - around 10 Amps
Sec: 100VDC or so, which is rectified, and filter trough capacitors. Able of outputting 30 amps.
But does the frequency have any thing to say in this?
Anyone, know any transformer design programs, or know where to buy one? Pref, ebay
Thanks in advance.
Christian.
Last edited: