Hi all,
I've got a MicroChip Pickit2 programmer that I connect to my own little dev board.
Unfortunately my projects all use Rb6 and Rb7 programming lines and sometimes Mclr / Re3.
I currently use a 4 pole switch to isolate these lines while the programmer does it job.
I know electronic switches like the 4053 etc are capable of handling these lines, but what I would like to know, is there any way the Pickit2 can enable these chips when it wants to program, so alleviating the need for constant manual switching ?
Thanks
Richard
I've got a MicroChip Pickit2 programmer that I connect to my own little dev board.
Unfortunately my projects all use Rb6 and Rb7 programming lines and sometimes Mclr / Re3.
I currently use a 4 pole switch to isolate these lines while the programmer does it job.
I know electronic switches like the 4053 etc are capable of handling these lines, but what I would like to know, is there any way the Pickit2 can enable these chips when it wants to program, so alleviating the need for constant manual switching ?
Thanks
Richard