I just wasted 2 hours trying to get an LCD to work on PORTA of this chip. I switched it to PORTC and then it worked fine...I checked the DS and couldnt see any possible issues. Could somebody enlighten me?
ANSEL was cleared.
Is CMCON cleared by default? thats the only thing I didnt try...
I just wasted 2 hours trying to get an LCD to work on PORTA of this chip. I switched it to PORTC and then it worked fine...I checked the DS and couldnt see any possible issues. Could somebody enlighten me?
ANSEL was cleared.
Is CMCON cleared by default? thats the only thing I didnt try...
Yea, im not using the 628A though, the 88X series takes care of that
Yea i have no clue either mike!
Im having a bad night
I soldered up the clock to get it off the breadboard, everything works EXCEPT!
Now it displays every number except 1 and 4?!?!? Perhaps I need a good night sleep to figure these two things out...
Hey Mike, I've been having this weird problem with my programmer (pickit 2 )
When I try to use ICSP, it doesnt recognize the chip, but when I plug it into the zif socket it works...I did work prior too. At first it did this with the pic16f88, then didnt work. Then it worked with the 882, but now doesnt work.