O ouranix New Member Feb 20, 2009 #1 hello there, i'm using an ultrasonic sensor and PIC16f877A and trying to do an interface between them PLZ any one can help... thanks
hello there, i'm using an ultrasonic sensor and PIC16f877A and trying to do an interface between them PLZ any one can help... thanks
O ouranix New Member Feb 20, 2009 #3 this sensor LV-MaxSonar®-EZ1™ High Performance Sonar Range Finder
blueroomelectronics Well-Known Member Feb 20, 2009 #4 You would use the TX / RX pins as the Sonars PIC16F676 will convert the range to serial data. Ignore the analog output.
You would use the TX / RX pins as the Sonars PIC16F676 will convert the range to serial data. Ignore the analog output.
O ouranix New Member Feb 20, 2009 #5 hi there, thanks I need to use the analoge output since my application require that, but I need a code that helps me read from my sensor.
hi there, thanks I need to use the analoge output since my application require that, but I need a code that helps me read from my sensor.
Nigel Goodwin Super Moderator Most Helpful Member Feb 20, 2009 #6 If it's just to read an analogue voltage, then my tutorials explain it.