Electrix
Member
Hi, I am using the PIC 16F84A for my summer project. I am facing a problem. I have used the pull up enable feature in the 16F84 for PORT B pins, but upon simulation I notice that my PortB input pins are not on a High State. All the steps leading to the enabling have been done. In my circuit out of the 8 Port B pins, 4 are output and 4 are input. The datasheet says that when the PB pin is configured as an o/p pin, the pull up feature is disabled, since 4 of my PB pins are outputs, could this be the problem ??
Awaiting your views..
Awaiting your views..