Inquisitive
Super Moderator
I use solder flux that is in a bottle and apply it with a small brush where needed when soldering. It is non-corrosive. It is Isopropyl Alcohol and Gum Rosin based. To clean up the rosin a high percentile isopropyl alcohol was used in the past. Which leads me to ask.
Does Isopropyl Alcohol remove conformal coatings on PCB's? My boards in the past have not had conformal coatings as they were handmade.
What should I use. Are there newer methods I should be looking at?
Any insight you could provide would be appreciated. Thanks for your interest and help.
Does Isopropyl Alcohol remove conformal coatings on PCB's? My boards in the past have not had conformal coatings as they were handmade.
What should I use. Are there newer methods I should be looking at?
Any insight you could provide would be appreciated. Thanks for your interest and help.