hey
well i am doing a project on pic16f877 and i coded it . now my problem is when i want to chek the signal from the output i cannot get the right output using the oscilloscop . if i do it using the analog chanel i get a sine wave with a high frequency and even if i dont place the probe i just get a smaller amplitude frequency. i tried using a digital channel , of no avail.
the chip is connected rite...
what i want to know i s how to use the oscilloscope... since my pic is operating at ...78.12 khz .. is tht the cos of me not getting a proper signal ???
well i am doing a project on pic16f877 and i coded it . now my problem is when i want to chek the signal from the output i cannot get the right output using the oscilloscop . if i do it using the analog chanel i get a sine wave with a high frequency and even if i dont place the probe i just get a smaller amplitude frequency. i tried using a digital channel , of no avail.
the chip is connected rite...
what i want to know i s how to use the oscilloscope... since my pic is operating at ...78.12 khz .. is tht the cos of me not getting a proper signal ???