calcs Vpp noise over a freq range from the specification OPA noise figure. How is this done?
The OPA376 has a low voltage noise on the order of 7.5 nV/√Hz at 1 kHz—0.8 μV p-p from 0.1 Hz to 10 Hz.
calcs Vpp noise over a freq range from the specification OPA noise figure. How is this done?
The OPA376 has a low voltage noise on the order of 7.5 nV/√Hz at 1 kHz—0.8 μV p-p from 0.1 Hz to 10 Hz.
You need the full noise spectrum to actually calculate the total equivalent noise. It's usually in the typical curves on the data sheet. The specs above are just single data points from the curve. It's been a while, but I remember that what you do is take the frequency range of interest and then break it into segments and calculate the noise for each range then sum them up.