Hello,
Ive just done a board layout, generated the files for the manufacturer from the cam processor and then gone back into the board layout and now when I check on DRC errors, ive got:
Dimension Errors and Overlap Errors.
I was drawing my parts in the schematic editor using the default 0.05 inch
and then on the board layout I switched to 0.025 inch for better control.
Could this be the reason why these errors are coming up and why ive got hashed lines.
Thanks,
Ben
Ive just done a board layout, generated the files for the manufacturer from the cam processor and then gone back into the board layout and now when I check on DRC errors, ive got:
Dimension Errors and Overlap Errors.
I was drawing my parts in the schematic editor using the default 0.05 inch
and then on the board layout I switched to 0.025 inch for better control.
Could this be the reason why these errors are coming up and why ive got hashed lines.
Thanks,
Ben