Yeah, if I should try a 100 I certainly will get two(one for each side). I must be missing something. BeerBelly must have been talking about the same thing as far as pin outs. I guess I don't understand what you guys are talking about. The schematics are nearly identical, but the pin numbers are different. Are you saying because of that they couldn't be interchangable even though schematically they appear the same?
Well, now that I think about it, I think I see what you guys are talking about. The pin arrangement might be identical but what each pin has on them must be different? They both must have 7 pins and would mount and connect to the CB in the same way but you are saying that each or some of their pin values are different. I find it curious that the 60 is numbered 1-7 but the 100 is numbered 2, 3, 4, 5, 7, 8, 9 (no pin 1 or pin 6). So I'm not quite sure how to interpret that. I guess I would have to have both to ohm out each for comparison. Right now I have not even removed either 60s. I am just assuming one is bad. I guess I should at least switch them and see if the problem switches to the other side or at least remove both and ohm each one out to see if they are same. At least that way I would be more knowledgable about what to expect the ohm readings of a good component to be. Right?
RLH